VCD dumping from VCS command line?

Dear Readers,

Dumping of signal value changes in VCD format can be enabled
in verilog by including the $dumpvars system task.

In addition to this method, VCS provides a way to enable
VCD dumping at compile time.

This can be achieved by including the following switch
at compile time: "+vcs+dumpvars[+filename]"

For example, consider the following case:

% cat test.v
module test;
reg clk;

initial begin
clk = 1'b0;
forever #5 clk = ~clk;

initial begin
#100 $finish;

% vcs test.v -V -l logfile -R +vcs+dumpvars+test.vcd

The $dumpvars system task is not specified in the verilog code above. Instead,
VCD dumping is enabled with the addition of the compile time switch "+vcs+dumpvars+test.vpd".

The result is equivalent to calling the following system tasks:


If the filename is not specified (ie. only +vcs+dumpvars is used), then the
filename defaults to "verilog.dump".

If both the system task ($dumpvars) and the compile-time switch (+vcs+dumpvars)
are specified, then the compile-time switch takes precedence.

No additional verilog code is needed when enabling VCD dumping using the compile
time switch.

Having compile time switch reduces little bit of code and makes life easy :-)

ASIC With Ankit

1 comment:

Unknown said...

Ankit is right...

A much more useful command line switch however is...

+vcs+vcdpluson -debug_pp

Using this one instead will give you a much fuller database (vpd) for debugging source files, and tracing the RTL.